Saltar al contenido principal

Introducción

The Hot Wheels Race System Controller may become unresponsive due to broken or disconnected wires. Heavy use or dropping can cause these disconnections. These wires may need to be reconnected or replaced. Take care when opening the controller as more wires could break.

Partes

No se especificaron partes.

  1. Remove the six screws located on the back of the controller using a JIS #1 screwdriver.
    • Remove the six screws located on the back of the controller using a JIS #1 screwdriver.

  2. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  3. Pop the front of the controller casing from the back and carefully lay the controller out with circuits exposed.
    • Pop the front of the controller casing from the back and carefully lay the controller out with circuits exposed.

  4. Check all wires for disconnections. They are color coated red, black, orange, and yellow. If wires are disconnected they can easily be reinserted as shown in photos.
    • Check all wires for disconnections. They are color coated red, black, orange, and yellow. If wires are disconnected they can easily be reinserted as shown in photos.

    • Some wires may require soldering which can be done with a soldering iron. The wire marked in red may need to be soldered but can sometimes be reattached.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 6

Todo El Tiempo: 80