Repara tus cosas Comunidad Tienda

Hoover T-Series WindTunnel Pet UH70102 Brush Roll Replacement

Introducción

This guide is intended to help you replace the brush roll on your vacuum. Please see the troubleshooting guide to determine if this needs replacement. Begin this step with the vacuum unplugged, and laying on the floor with the bottom facing towards you.

Qué necesitas

  1. Hoover T-Series WindTunnel Pet UH70102 Brush Roll Replacement, Brush Roll: paso 1, imagen 1 de 3 Hoover T-Series WindTunnel Pet UH70102 Brush Roll Replacement, Brush Roll: paso 1, imagen 2 de 3 Hoover T-Series WindTunnel Pet UH70102 Brush Roll Replacement, Brush Roll: paso 1, imagen 3 de 3

    • Push the red release lever to the right.

    • Turn the red switch counterclockwise.

    • Tilt the bottom of the plastic tray out towards you and pull it off the vacuum.

    Traducir

  3. Hoover T-Series WindTunnel Pet UH70102 Brush Roll Replacement: paso 2, imagen 1 de 1

    • Pull the brush roll out of vacuum.

    • Remove the belt from brush roller

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 5 otros colaboradores

Sophia Stockburger

Miembro Desde 01/22/18

566 Reputación

5 Guías creadas

Insignias: 7

+ 4 más insignias

Equipo

Cal Poly, Team S11-G2, Banghart Winter 2018 Miembro de Cal Poly, Team S11-G2, Banghart Winter 2018

CPSU-BANGHART-W18S11G2

5 Miembros

9 Guías creadas

3 comentarios

When you turn the vacuum on the brush roller works until you release the handle to start vacuuming then the brush roller stops. How do I correct this issue?

Brenda Brenda - Contestar

Did you ever get an answer on this issue or figure it out? I am having the same problem!

Val -

Mine does the same thing. I have replaced the belt but that didn’t help

Ann - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 14

Todo El Tiempo: 979