Saltar al contenido principal

Holmes HEH8031 Safety Weight Replacement

Qué necesitas

  1. Holmes HEH8031 Safety Weight Replacement, Housing: paso 1, imagen 1 de 1
    • Ensure the device is unplugged from the wall outlet.

  2. Holmes HEH8031 Safety Weight Replacement: paso 2, imagen 1 de 1
    • Remove eight 12-mm Phillips #2 screws from the back cover.

  3. Holmes HEH8031 Safety Weight Replacement: paso 3, imagen 1 de 2 Holmes HEH8031 Safety Weight Replacement: paso 3, imagen 2 de 2
    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

  4. Holmes HEH8031 Safety Weight Replacement, Circuit Board Removal: paso 4, imagen 1 de 1
    • Remove four 12mm Phillips #2 screws from the circuit board.

  5. Holmes HEH8031 Safety Weight Replacement, Safety Weight: paso 5, imagen 1 de 2 Holmes HEH8031 Safety Weight Replacement, Safety Weight: paso 5, imagen 2 de 2
    • Remove wires from safety weight, as shown.

    • Pull upward on the blue connectors.

    • If connectors are tough to remove, try wiggling while pulling upward.

  6. Holmes HEH8031 Safety Weight Replacement: paso 6, imagen 1 de 1
    • Unscrew the Phillips #2 10 mm screw from the safety weight on the rear housing panel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Deanna Jack

Miembro Desde 10/12/16

333 Reputación

4 Guías creadas

Equipo

IUPUI, Team 2-1, Baechle Fall 2016 Miembro de IUPUI, Team 2-1, Baechle Fall 2016

IUPUI-BAECHLE-F16S2G1

4 Miembros

16 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 4

Todo El Tiempo: 537