Saltar al contenido principal

Holmes HEH8031 Control Buttons Replacement

Qué necesitas

  1. Holmes HEH8031 Control Buttons Replacement, Housing: paso 1, imagen 1 de 1
    • Ensure the device is unplugged from the wall outlet.

  2. Holmes HEH8031 Control Buttons Replacement: paso 2, imagen 1 de 1
    • Remove eight 12-mm Phillips #2 screws from the back cover.

  3. Holmes HEH8031 Control Buttons Replacement: paso 3, imagen 1 de 2 Holmes HEH8031 Control Buttons Replacement: paso 3, imagen 2 de 2
    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

  4. Holmes HEH8031 Control Buttons Replacement, Circuit Board Removal: paso 4, imagen 1 de 1
    • Remove four 12mm Phillips #2 screws from the circuit board.

  5. Holmes HEH8031 Control Buttons Replacement, Control Buttons: paso 5, imagen 1 de 3 Holmes HEH8031 Control Buttons Replacement, Control Buttons: paso 5, imagen 2 de 3 Holmes HEH8031 Control Buttons Replacement, Control Buttons: paso 5, imagen 3 de 3
    • Remove the two Phillips #2 12mm screws from the button retainer.

    • Lift the button retainer off.

    • Remove the interconnected buttons.

    • If the buttons are broken, replace them.

    • If the buttons are sticking, clean them in warm soapy water and allow to dry.

  6. Holmes HEH8031 Control Buttons Replacement: paso 6, imagen 1 de 3 Holmes HEH8031 Control Buttons Replacement: paso 6, imagen 2 de 3 Holmes HEH8031 Control Buttons Replacement: paso 6, imagen 3 de 3
    • Using light finger pressure, carefully push the black plastic tabs off the white plastic hooks.

    • Remove the black plastic bracket out through the front of the heater housing.

    • Remove the two Phillips #2 12mm screws and remove the clear window from the black plastic bracket.

    • If the buttons were sticking, clean the black plastic bracket in warm soapy water and allow to dry.

    • If the clear window was dirty, clean it in warm soapy water and allow to dry.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Chris Shaffer

Miembro Desde 10/12/16

255 Reputación

2 Guías creadas

Equipo

IUPUI, Team 2-1, Baechle Fall 2016 Miembro de IUPUI, Team 2-1, Baechle Fall 2016

IUPUI-BAECHLE-F16S2G1

4 Miembros

16 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 4

Todo El Tiempo: 473