Repara tus cosas Comunidad Tienda

Holmes HEH8031 Circuit Board Replacement

Introducción

Repair or replace your Holmes HEH8031 heater circuit board.

Qué necesitas

  1. Holmes HEH8031 Circuit Board Replacement, Housing: paso 1, imagen 1 de 1

    • Ensure the device is unplugged from the wall outlet.

    Traducir

  2. Holmes HEH8031 Circuit Board Replacement: paso 2, imagen 1 de 1

    • Remove eight 12-mm Phillips #2 screws from the back cover.

    Traducir

  4. Holmes HEH8031 Circuit Board Replacement: paso 3, imagen 1 de 2 Holmes HEH8031 Circuit Board Replacement: paso 3, imagen 2 de 2

    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

    Traducir

  5. Holmes HEH8031 Circuit Board Replacement, Circuit Board Removal: paso 4, imagen 1 de 1

    • Remove four 12mm Phillips #2 screws from the circuit board.

    Traducir

  6. Holmes HEH8031 Circuit Board Replacement, Circuit Board: paso 5, imagen 1 de 3 Holmes HEH8031 Circuit Board Replacement, Circuit Board: paso 5, imagen 2 de 3 Holmes HEH8031 Circuit Board Replacement, Circuit Board: paso 5, imagen 3 de 3

    • Desolder the BLACK wires from the "AC-L" point and "T/S" point.

    • Learn how to solder and desolder connections here!

    • Desolder the WHITE wire from the "AC-N" point.

    • Desolder the RED wire from the "FAN-RED".

    • Desolder the GREY wire from the "24V" point.

    • Desolder the BROWN wires from "HEAT1," and "HEAT2" points.

    • Be sure to use desoldering wick when you remove the wire connections.

    Traducir

  7. Holmes HEH8031 Circuit Board Replacement: paso 6, imagen 1 de 2 Holmes HEH8031 Circuit Board Replacement: paso 6, imagen 2 de 2

    • Desolder the WHITE connector (attached to the GRAY wire coming of the thermostat) from the "NTC101" point.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 2 otros colaboradores

Chris Shaffer

Miembro Desde 10/12/16

255 Reputación

2 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

IUPUI, Team 2-1, Baechle Fall 2016 Miembro de IUPUI, Team 2-1, Baechle Fall 2016

IUPUI-BAECHLE-F16S2G1

4 Miembros

16 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 4

Todo El Tiempo: 940