Repara tus cosas Comunidad Tienda

Harman Kardon Onyx Studio 2 Front Panel Replacement

Introducción

If you need to access the insides of your speaker, you first have to take apart the device. This guide walks you through how to take apart the front panel.

Qué necesitas

  1. Harman Kardon Onyx Studio 2 Front Panel Replacement, Front Panel: paso 1, imagen 1 de 3 Harman Kardon Onyx Studio 2 Front Panel Replacement, Front Panel: paso 1, imagen 2 de 3 Harman Kardon Onyx Studio 2 Front Panel Replacement, Front Panel: paso 1, imagen 3 de 3

    • Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.

    Traducir

  2. Harman Kardon Onyx Studio 2 Front Panel Replacement: paso 2, imagen 1 de 2 Harman Kardon Onyx Studio 2 Front Panel Replacement: paso 2, imagen 2 de 2

    • Remove the five 14.4 mm T10 Torx screws.

    Traducir

  4. Harman Kardon Onyx Studio 2 Front Panel Replacement: paso 3, imagen 1 de 1

    • Gently pull the front apart from the back.

    Traducir

  5. Harman Kardon Onyx Studio 2 Front Panel Replacement: paso 4, imagen 1 de 2 Harman Kardon Onyx Studio 2 Front Panel Replacement: paso 4, imagen 2 de 2

    • Remove the four wires connecting the front and back panels.

    • Pinch the connector tab and pull gently upwards.

    • Repeat for the other three connectors.

    Traducir
Conclusión

To reassemble, follow these steps in reverse order.

2 personas más completaron esta guía.

Autor

con 2 otros colaboradores

Alexandra Achtenberg

Miembro Desde 02/02/17

2,031 Reputación

6 Guías creadas

Insignias: 16

+ 13 más insignias

Equipo

USF Tampa, Team 16-5, Blackwell Spring 2017 Miembro de USF Tampa, Team 16-5, Blackwell Spring 2017

USFT-BLACKWELL-S17S16G5

3 Miembros

24 Guías creadas

Un comentario

Hi, I have the ONYX STUDIO with the silver ring that serves as the stand and the handle at the same time. After removing the front grill, I find the same five holes as it is shown on your pics but there are no screws. I can just see a bottom made of plastic. Do you have experience with that? Is that just some cover I can get thru using a screwdriver and I find the screws beneath?

I want to look inside as I am facing the problem with not working battery. As soon as I unplug the power source, it stops working.

Thank you for your comments.

Vaclav Matoulek - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 6

Ultimos 30 días: 43

Todo El Tiempo: 6,037