Saltar al contenido principal

Introducción

If your Invoke is experiencing problems with powering on after being plugged in, there could be an issue with a weak or broken power port.

Partes

No se especificaron partes.

  1. Use a metal spudger to remove rubber bottom. Use a metal spudger to remove rubber bottom.
    • Use a metal spudger to remove rubber bottom.

  2. Use a #10 Torx screwdriver to remove four 14 mm screws. Use a #10 Torx screwdriver to remove four 14 mm screws.
    • Use a #10 Torx screwdriver to remove four 14 mm screws.

  3. Kits de reparación de iPhone X

    ¿Garantía vencida? No te preocupes, tenemos la solución.

    Comprar Ahora

    Kits de reparación de iPhone X

    ¿Garantía vencida? No te preocupes, tenemos la solución.

    Comprar Ahora
  4. Firm grip the bottom and wiggle upwards to remove bottom. Firm grip the bottom and wiggle upwards to remove bottom.
    • Firm grip the bottom and wiggle upwards to remove bottom.

  5. Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports. Pull board up lightly. Pull board up lightly.
    • Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports.

    • Pull board up lightly.

  6. Pull cable to disconnect board from device. For replacement of service port, you will have to replace whole board that the port is attached to.
    • Pull cable to disconnect board from device.

    • For replacement of service port, you will have to replace whole board that the port is attached to.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

can I buy that power port circuit board from HK direct?

crokeclan - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 66