Saltar al contenido principal

Handset Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. Handset Replacement, Battery: paso 1, imagen 1 de 2 Handset Replacement, Battery: paso 1, imagen 2 de 2
    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

  2. Handset Replacement: paso 2, imagen 1 de 1
    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

  3. Handset Replacement, Handset: paso 3, imagen 1 de 1
    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

  4. Handset Replacement: paso 4, imagen 1 de 2 Handset Replacement: paso 4, imagen 2 de 2
    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

  5. Handset Replacement: paso 5, imagen 1 de 2 Handset Replacement: paso 5, imagen 2 de 2
    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Caleb Thomas

Miembro Desde 09/29/16

161 Reputación

2 Guías creadas

Equipo

IUPUI, Team 3-3, Harley Fall 2016 Miembro de IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Miembros

17 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 50