Hamilton-T1 Oxygen Cells Replacement - Guía de reparación iFixit

Introducción

This guide is created for the replacement of oxygen cells in the Hamilton-T1 Ventilator. Replacing the oxygen cells is a crucial step in maintaining and keeping a working ventilator.

NOTE:

Replace the oxygen cell with genuine Hamilton Medical parts only; otherwise, oxygen measurement will not function. To prevent a permanent alarm make sure to use special Hamilton Medical oxygen cells only.
To prevent leakage within the ventilator, make sure an oxygen cell is installed at all times, even if you use an external monitor or disable oxygen monitoring.

Qué necesitas

Paso 1 Oxygen Cells

Hamilton-T1 Oxygen Cells Replacement, Oxygen Cells: paso 1, imagen 1 de 1

Flip device around until the back panel is exposed.

Paso 2

Hamilton-T1 Oxygen Cells Replacement: paso 2, imagen 1 de 1

Remove the screw in the bottom center of the panel, and then take the panel off.

Paso 3

Hamilton-T1 Oxygen Cells Replacement: paso 3, imagen 1 de 1

Disconnect the oxygen cell by removing the tube.
Then twist the cell counter-clockwise and pull to remove the oxygen cell.
Install the new oxygen cell and put the back cover on.

Paso 4

After the cell is installed. Run the oxygen cell calibration.
Oxygen calibration guide can be found in 3-11 of the Hamilton-T1 operations manual.

Conclusión

After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.

Documentos Adjuntos

HAMILTON-T1 Operator's Manual SW2.1x EN

PDF - 4.17 mb

Ver

Autor

con 1 otro colaborador

Tyler

Miembro Desde 04/09/20

114 Reputación

1 Guía escrita

+1 mas insignia

Equipo

Cal Poly, Team S11-G24, Paton Spring 2020 Miembro de Cal Poly, Team S11-G24, Paton Spring 2020

CPSU-PATON-S20S11G24

3 Miembros

3 Guías creadas

0 comentarios

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 15

Ultimos 30 días: 64

Todo El Tiempo: 2,254