Hamilton Beach 64650 Mixer Release Button Replacement

Introducción

This page will guide you through the replacement of the mixer release button on your Hamilton Beach Classic Stand Mixer 64650. This piece may break easily from normal use and it is important to remain in working order to make sure that the mixer's handle stays secured on the top of the stand.

Qué necesitas

Paso 1 Mixer Release Button

Hamilton Beach 64650 Mixer Release Button Replacement, Mixer Release Button: paso 1, imagen 1 de 3

Hamilton Beach 64650 Mixer Release Button Replacement, Mixer Release Button: paso 1, imagen 2 de 3

Hamilton Beach 64650 Mixer Release Button Replacement, Mixer Release Button: paso 1, imagen 3 de 3

Depress mixer release button fully and lift mixer off of the platform.
Remove the bowl from the stand.

Editar

Paso 2

Hamilton Beach 64650 Mixer Release Button Replacement: paso 2, imagen 3 de 3

Remove and set aside the three 1.3 mm Philips #2 screws holding the plastic cover in place.

Editar

Paso 3

Shift the cover to allow the plastic retaining hook to fit through the hole easily.
Lift the cover away.

Editar

Paso 4

Hamilton Beach 64650 Mixer Release Button Replacement: paso 4, imagen 3 de 3

Fully depress the mixer release button, pushing it through the mounting hole.
Push the button slightly upwards once it is inside the stand to access the spring underneath it.
Carefully remove the button from the stand while leaving spring in place.