Repara tus cosas Comunidad Tienda

Hamilton Beach 48464 Heating Plate Replacement

Introducción

Make sure that the device is unplugged and removed of all contents before starting this repair. Also be careful when removing and inserting the Heat Plate.

Qué necesitas

  1. Hamilton Beach 48464 Heating Plate Replacement, Heating Plate: paso 1, imagen 1 de 1

    • To begin, carefully open the top lid of the Brew Station.

    Traducir

  2. Hamilton Beach 48464 Heating Plate Replacement: paso 2, imagen 1 de 1

    • Gently pull out the filter basket from the Brew Station and set it to the side.

    Traducir

  3. Hamilton Beach 48464 Heating Plate Replacement: paso 3, imagen 1 de 1

    • Grab the handle and pull up to remove the top container.

    • Set this piece close by as you will be needing it for a future step.

    Traducir

  5. Hamilton Beach 48464 Heating Plate Replacement: paso 4, imagen 1 de 2 Hamilton Beach 48464 Heating Plate Replacement: paso 4, imagen 2 de 2

    • Using the Crown Bolt #8 Steel Spanner, unscrew the four 8-mm screws labeled in a red outline.

    Traducir

  6. Hamilton Beach 48464 Heating Plate Replacement: paso 5, imagen 1 de 2 Hamilton Beach 48464 Heating Plate Replacement: paso 5, imagen 2 de 2

    • Check again to make sure that the coffee maker is not plugged in.

    • Once the screws are removed, carefully pull off the metal piece.

    • Once the piece is removed, you will be able to access the heater.

    Traducir

  7. Hamilton Beach 48464 Heating Plate Replacement: paso 6, imagen 1 de 2 Hamilton Beach 48464 Heating Plate Replacement: paso 6, imagen 2 de 2

    • This step involves using the top contained that you put aside in step 3.

    • Using the Philips 2 Screwdriver, unscrew the eight 8-mm screws labeled in a red outline.

    Traducir

  8. Hamilton Beach 48464 Heating Plate Replacement: paso 7, imagen 1 de 1

    • Once screws are removed, carefully pull out the metal piece from the unit. This is the top part of the heater in the Brew Staton.

    • There are rubber washers inside each of the 8 holes on the piece of metal. Be careful to not let any fall out when handling the piece.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 2 otros colaboradores

Michael Damico

Miembro Desde 02/10/16

661 Reputación

6 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

USF Tampa, Team 14-1, Lacy Spring 2016 Miembro de USF Tampa, Team 14-1, Lacy Spring 2016

USFT-LACY-S16S14G1

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 17

Todo El Tiempo: 970