Saltar al contenido principal

Introducción

For this walk-through, we are going to learn how to replace the battery to a Half Hunter Necklace Pocket Watch. These instructions will also work for most types of Necklace Pocket Watches and do not require any specific skills to complete.

Partes

No se especificaron partes.

  1. Remove the back of the pocket watch by locating the small indent on the side and pushing up on the back until it comes off. Set the cover aside so that you can put it back on once you finish.
    • Remove the back of the pocket watch by locating the small indent on the side and pushing up on the back until it comes off.

    • Set the cover aside so that you can put it back on once you finish.

  2. Remove the plastic ring around the battery and inner workings of the watch by using a pair of tweezers to grab onto the plastic and lift it out of the watch. Set the plastic ring aside and do not dispose of it.
    • Remove the plastic ring around the battery and inner workings of the watch by using a pair of tweezers to grab onto the plastic and lift it out of the watch.

    • Set the plastic ring aside and do not dispose of it.

  3. Take out the battery carefully using the set of tweezers to push on the underside of the battery. With enough pushing, the battery will fall out. Set the old battery aside or dispose of it how you please.
    • Take out the battery carefully using the set of tweezers to push on the underside of the battery. With enough pushing, the battery will fall out.

    • Set the old battery aside or dispose of it how you please.

  4. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  5. Replace the old battery with a new one by carefully sliding it back into place until it sits flat inside of the watch.
    • Replace the old battery with a new one by carefully sliding it back into place until it sits flat inside of the watch.

  6. Reinsert the plastic covering into the pocket watch where it previously was by using the tweezers again until the plastic is also sitting flat in the back of the watch.
    • Reinsert the plastic covering into the pocket watch where it previously was by using the tweezers again until the plastic is also sitting flat in the back of the watch.

  7. Put the cover of the watch back on by placing it and pushing it down until you hear a small click.
    • Put the cover of the watch back on by placing it and pushing it down until you hear a small click.

  8. Pull up on the knob at the top of the watch and twist either left or right to readjust the time.
    • Pull up on the knob at the top of the watch and twist either left or right to readjust the time.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Eren Barrick

Miembro Desde 22/10/18

145 Reputación

1 Guía escrita

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 4

Todo El Tiempo: 51