Saltar al contenido principal

Hair Dryer Fan/ Motor Assembly Replacement

Qué necesitas

  1. Hair Dryer Fan/ Motor Assembly Replacement, Nozzle: paso 1, imagen 1 de 2 Hair Dryer Fan/ Motor Assembly Replacement, Nozzle: paso 1, imagen 2 de 2
    • Remove the black air concentrating nozzle by gently twisting and pulling the nozzle.

    • If nozzle is not attached, skip to next step.

  2. Hair Dryer Fan/ Motor Assembly Replacement, Grating: paso 2, imagen 1 de 1
    • Using a screwdriver, remove the screw located underneath the air concentrating nozzle. This screw attaches the hair dryer body to the hair dryer grating.

    • For most hair dryers, use a Phillips #1 screwdriver. For hair dryers with smaller screws, consider using a Phillips #00 screwdriver.

  3. Hair Dryer Fan/ Motor Assembly Replacement: paso 3, imagen 1 de 1
    • Detach the hair dryer grating from the body by gently twisting the grating from side to side.

  4. Hair Dryer Fan/ Motor Assembly Replacement: paso 4, imagen 1 de 1
    • Separate the hair dryer grating into the three pieces seen in the image.

  5. Hair Dryer Fan/ Motor Assembly Replacement, Fan/ Motor Assembly: paso 5, imagen 1 de 1
    • Locate the screws on the handle and remove with a Phillips screwdriver.

  6. Hair Dryer Fan/ Motor Assembly Replacement: paso 6, imagen 1 de 1
    • Carefully separate the plastic case with the Plastic Opening Tool.

  7. Hair Dryer Fan/ Motor Assembly Replacement: paso 7, imagen 1 de 1
    • After removing the plastic case, locate the fan towards the back of the hair dryer.

  8. Hair Dryer Fan/ Motor Assembly Replacement: paso 8, imagen 1 de 1
    • Remove the screw that is holding the fan to the motor using a Phillips screwdriver.

  9. Hair Dryer Fan/ Motor Assembly Replacement: paso 9, imagen 1 de 1
    • Remove the screws holding the motor to the casing using a Phillips screwdriver.

    • NOTE: This may be unnecessary if the fan can be removed without using a screwdriver.

  10. Hair Dryer Fan/ Motor Assembly Replacement: paso 10, imagen 1 de 1
    • Isolate the fan from the rest of the dryer.

    • Remove the screws holding the motor in place. Replace with the new component.

  11. Hair Dryer Fan/ Motor Assembly Replacement: paso 11, imagen 1 de 1
    • Solder the wires to the motor. Refer to the soldering page below, which will help you replace this component.

    • Soldering Skills

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Mitch

Miembro Desde 10/04/12

34 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 24-29, Regan Fall 2012 Miembro de Cal Poly, Team 24-29, Regan Fall 2012

CPSU-REGAN-F12S24G29

5 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 18

Ultimos 30 días: 61

Todo El Tiempo: 15,839