Introducción

Instead of buying a new hairdryer, simply use this guide to replace the motor on your old one!

  1. Identify the black air concentrating nozzle.
    • Identify the black air concentrating nozzle.

  2. Remove the black air concentrating nozzle by gently twisting and pulling the nozzle.
    • Remove the black air concentrating nozzle by gently twisting and pulling the nozzle.

  3. Using a screwdriver, remove the screw located underneath the air concentrating nozzle. This screw attaches the hair dryer body to the hair dryer grating.
    • Using a screwdriver, remove the screw located underneath the air concentrating nozzle. This screw attaches the hair dryer body to the hair dryer grating.

    • The purpose of this guide is to demonstrate the repair steps for a generic hair dryer. We do not specify screw sizes because screw sizes can differ between hair dryers. For most hair dryers, use a Phillips #1 Screwdriver. For hair dryers with smaller screws, consider using a Phillips #00 Screwdriver.

  4. Detach the hair dryer grating from the body by gently twisting the grating from side to side.
    • Detach the hair dryer grating from the body by gently twisting the grating from side to side.

  5. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  6. Separate the hair dryer grating into the three pieces seen in the image.
    • Separate the hair dryer grating into the three pieces seen in the image.

  7. Locate the screws on the handle and remove with a Phillips screwdriver.
    • Locate the screws on the handle and remove with a Phillips screwdriver.

  8. Carefully separate the plastic case with the Plastic Opening Tool.
    • Carefully separate the plastic case with the Plastic Opening Tool.

  9. After removing the plastic case, locate the fan towards the back of the hair dryer.
    • After removing the plastic case, locate the fan towards the back of the hair dryer.

  10. Remove the screw that is holding the fan to the motor using a Phillips screwdriver.
    • Remove the screw that is holding the fan to the motor using a Phillips screwdriver.

  11. Remove the screws holding the motor to the casing using a Phillips screwdriver.
    • Remove the screws holding the motor to the casing using a Phillips screwdriver.

    • NOTE: This may be unnecessary if the fan can be removed without using a screwdriver.

  12. Isolate the fan from the rest of the dryer.
    • Isolate the fan from the rest of the dryer.

    • Remove the screws holding the motor in place. Replace with the new component.

  13. Solder the wires to the motor. Refer to the soldering page below, which will help you replace this component.
    • Solder the wires to the motor. Refer to the soldering page below, which will help you replace this component.

    • Soldering Skills

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Mitch

Miembro Desde 04/10/12

31 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 24-29, Regan Fall 2012 Miembro de Cal Poly, Team 24-29, Regan Fall 2012

CPSU-REGAN-F12S24G29

5 Miembros

6 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 4

Últimos 7 Días: 54

Últimos 30 Días: 201

Todo El Tiempo: 9,639