Saltar al contenido principal

HTC One X Plus Screen Replacement

Qué necesitas

  1. HTC One X Plus Screen Replacement, Screen: paso 1, imagen 1 de 1
    • Power off your device.

    • Insert a pin, paper clip, or very small piece of metal in the hole next to the micro sim card holder to remove it.

    • The sim card slot is located on the top edge of the device.

  2. HTC One X Plus Screen Replacement: paso 2, imagen 1 de 3 HTC One X Plus Screen Replacement: paso 2, imagen 2 de 3 HTC One X Plus Screen Replacement: paso 2, imagen 3 de 3
    • Using plastic opening tools, pry open the bottom of the device first.

    • You will hear clicking sounds as the sides of the device detach from the screen.

    • Once both sides are detached, use the suction cup tool to remove the screen completely from the black encasing.

  3. HTC One X Plus Screen Replacement: paso 3, imagen 1 de 3 HTC One X Plus Screen Replacement: paso 3, imagen 2 de 3 HTC One X Plus Screen Replacement: paso 3, imagen 3 de 3
    • Remove the five 2.4 mm screws using a Phillips #000 screwdriver.

    • Remove the plastic cover.

  4. HTC One X Plus Screen Replacement: paso 4, imagen 1 de 3 HTC One X Plus Screen Replacement: paso 4, imagen 2 de 3 HTC One X Plus Screen Replacement: paso 4, imagen 3 de 3
    • Use a Phillips #000 screwdriver to remove the two 3.4 mm screws.

    • Remove the PCB board and antenna.

  5. HTC One X Plus Screen Replacement: paso 5, imagen 1 de 2 HTC One X Plus Screen Replacement: paso 5, imagen 2 de 2
    • Use tweezers to disconnect the power button flex cable.

  6. HTC One X Plus Screen Replacement: paso 6, imagen 1 de 3 HTC One X Plus Screen Replacement: paso 6, imagen 2 de 3 HTC One X Plus Screen Replacement: paso 6, imagen 3 de 3
    • Disconnect the battery's six pin connector from the motherboard.

    • Remove the battery by pulling it upwards.

  7. HTC One X Plus Screen Replacement: paso 7, imagen 1 de 1
    • Disconnect the screen from the digitizer.

    • Use a plastic opening tool to gently disconnect the screen from the digitizer.

    • You may have to use heat to loosen adhesive securing the screen.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jason Melo

Miembro Desde 08/26/15

483 Reputación

4 Guías creadas

Equipo

USF Tampa, Team 3-3, Eyestone Fall 2015 Miembro de USF Tampa, Team 3-3, Eyestone Fall 2015

USFT-EYESTONE-F15S3G3

3 Miembros

10 Guías creadas

Un comentario

Man, this did nothing but break my International One X+. There were so many instructions missing.

Garrett Reyman - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 1,841