Saltar al contenido principal

HTC HD2 Camera Replacement

Qué necesitas

  1. HTC HD2 Camera Replacement, Battery: paso 1, imagen 1 de 1
    • Carefully pull the rear cover from the back of the phone.

    • Place a finger beneath the small lip on the left side of the battery.

  2. HTC HD2 Camera Replacement: paso 2, imagen 1 de 2 HTC HD2 Camera Replacement: paso 2, imagen 2 de 2
    • Lay the phone down on it's screen.

    • Lift up on the lip and pull the battery from the phone.

  3. HTC HD2 Camera Replacement, Midframe: paso 3, imagen 1 de 2 HTC HD2 Camera Replacement, Midframe: paso 3, imagen 2 de 2
    • Remove the four black 3.5mm T5 screws from the back of the phone.

  4. HTC HD2 Camera Replacement: paso 4, imagen 1 de 2 HTC HD2 Camera Replacement: paso 4, imagen 2 de 2
    • Insert the flat end of a spudger between the midframe and the display.

    • Slide the spudger along the seam between the frame and the display.

    • Using the spudger for leverage, carefully pry the midframe away from the display assembly.

    • This process will take some effort. Continue to pry slowly and carefully until the frame begins to detach.

    • As it releases, pull the midframe away from the phone.

    • The volume control tab may fall off during removal. It can be easily reattached.

  5. HTC HD2 Camera Replacement, Camera: paso 5, imagen 1 de 3 HTC HD2 Camera Replacement, Camera: paso 5, imagen 2 de 3 HTC HD2 Camera Replacement, Camera: paso 5, imagen 3 de 3
    • Disconnect the flash cable from its socket in the bottom of the motherboard.

    • Carefully pull the cable from its groove in the frame, working your way back to the camera.

  6. HTC HD2 Camera Replacement: paso 6, imagen 1 de 3 HTC HD2 Camera Replacement: paso 6, imagen 2 de 3 HTC HD2 Camera Replacement: paso 6, imagen 3 de 3
    • Pull the camera flash and cover off of the board.

    • You may need to peel back the sticker that sits behind the battery.

    • Work carefully. Excessive force can damage the camera or motherboard.

  7. HTC HD2 Camera Replacement: paso 7, imagen 1 de 1
    • Around the camera is a thin shielding. Remove it with tweezers.

    • Using tweezers, remove the primary camera.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Sam Luedloff

Miembro Desde 04/12/11

727 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 24-55, Amido Spring 2011 Miembro de Cal Poly, Team 24-55, Amido Spring 2011

CPSU-AMIDO-S11S24G55

5 Miembros

16 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 7,911