Saltar al contenido principal

HTC Desire HTC Desire Speaker Replacement

Qué necesitas

  1. HTC Desire HTC Desire Speaker Replacement, Battery: paso 1, imagen 1 de 2 HTC Desire HTC Desire Speaker Replacement, Battery: paso 1, imagen 2 de 2
    • Insert flat end of spudger into slot on the top of phone to pry off the back plate.

  2. HTC Desire HTC Desire Speaker Replacement: paso 2, imagen 1 de 2 HTC Desire HTC Desire Speaker Replacement: paso 2, imagen 2 de 2
    • Use flat edge of spudger to lift the bottom right corner of the battery.

    • Lift the battery out of the phone.

  3. HTC Desire HTC Desire Speaker Replacement, Vibrator: paso 3, imagen 1 de 1
    • Remove the lower, two 0.5 mm screws using Torx T5 screwdriver.

  4. HTC Desire HTC Desire Speaker Replacement: paso 4, imagen 1 de 2 HTC Desire HTC Desire Speaker Replacement: paso 4, imagen 2 de 2
    • Use spudger to pry vibrator panel off.

  5. HTC Desire HTC Desire Speaker Replacement: paso 5, imagen 1 de 2 HTC Desire HTC Desire Speaker Replacement: paso 5, imagen 2 de 2
    • Use spudger to remove the vibrator.

  6. HTC Desire HTC Desire Speaker Replacement, HTC Desire Speaker: paso 6, imagen 1 de 2 HTC Desire HTC Desire Speaker Replacement, HTC Desire Speaker: paso 6, imagen 2 de 2
    • Take out the upper, two 0.5 mm Torx screws with a Torx T5 bit.

  7. HTC Desire HTC Desire Speaker Replacement: paso 7, imagen 1 de 1
    • Take the middle 0.3 mm phillips screw out with the phillips J000 tip.

  8. HTC Desire HTC Desire Speaker Replacement: paso 8, imagen 1 de 3 HTC Desire HTC Desire Speaker Replacement: paso 8, imagen 2 de 3 HTC Desire HTC Desire Speaker Replacement: paso 8, imagen 3 de 3
    • Using the spudger, pry up to remove the battery holder.

  9. HTC Desire HTC Desire Speaker Replacement: paso 9, imagen 1 de 3 HTC Desire HTC Desire Speaker Replacement: paso 9, imagen 2 de 3 HTC Desire HTC Desire Speaker Replacement: paso 9, imagen 3 de 3
    • Using the spudger, pry the speaker out of its place.

  10. HTC Desire HTC Desire Speaker Replacement: paso 10, imagen 1 de 1
    • With the springs up, place the new speaker into position.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Scott Olson

Miembro Desde 10/22/15

274 Reputación

1 Guía escrita

Equipo

Montana Tech, Team 10-2, Shirk Fall 2015 Miembro de Montana Tech, Team 10-2, Shirk Fall 2015

MTUM-SHIRK-F15S10G2

4 Miembros

8 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 10

Todo El Tiempo: 1,177