Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tools to remove the plastic speaker covers that are attached through an adhesive layer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the T5 Torx screwdriver to remove the four screws in each corner.
-
Make sure to take out any SD cards, located on the left side of the phone before proceeding to the next step.
-
Use the plastic opening tool to pry the front of the device off. Fully go around the front with the plastic opening tool before attempting to pull it off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Dislocate the small piece with the wires connected using a nylon spudger.
-
Loosen the adhesive layer for the battery by running a hair dryer over it briefly. After the adhesive is loosened you can pry the battery out with a plastic opening tool.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After prying, simply lift the battery up and out of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After the battery has been removed, there are two screws that also need to be removed
-
There are two gold strips that you must disconnect from the motherboard, They simply pop right off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the circular piece from the motherboard.
-
Proceed to pry off the motherboard. Go around all edges with the plastic opening tool and it should come off with ease.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Next, the motherboard should still be connected by a wire that leads to the bottom portion of the phone.
-
To remove the black plastic piece there is one screw that needs to be removed then you can pry it off with the plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To fully remove the motherboard the last step is to disconnect the wire that was previously mentioned.
-
Remove the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After the phone is gutted, all that is left is to pry the actual screen off from the backing and prepare for replacement.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.