Partes

No se requieren partes.

Flip the HP iPAQ HW6515 over with the screen facing down.
  • Flip the HP iPAQ HW6515 over with the screen facing down.

  • Take the back cover off by pressing on the small silver button while pulling back then up on the case.

  • Place the back of the case aside for now.

Agregar Comentario

Remove the battery by pulling up on the black tab.
  • Remove the battery by pulling up on the black tab.

Agregar Comentario

  • Unscrew the four screws using the T6 hexagonal star screwdriver.

  • Unscrew the middle screw using the Phillips 00 screwdriver.

  • "Warranty VOID if broken" sticker might be covering the middle screw, if this is the case, peel it off to reveal the screw.

Agregar Comentario

  • Use the plastic opening tool to pry apart the covers along the bottom of the phone.

  • Slide the plastic opening tool along the seam until the two halves of the case separate.

Agregar Comentario

  • Unplug the sensor wire that connects the two halves of the case before pulling the two halves apart. Not doing so will damage the sensor wire.

Agregar Comentario

  • Gently pull off the black rubber square covering the LED light.

  • The LED is now exposed.

  • Wedge the plastic opening tool under the LED to pop it out and expose its wire.

  • Using your index finger and thumb, unplug the wire from the phone and remove the LED.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Steven Vo

Miembro Desde 02/04/12

33 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 15-17, Forte Spring 2012 Miembro de Cal Poly, Team 15-17, Forte Spring 2012

CPSU-FORTE-S12S15G17

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,038