Repara tus cosas Comunidad Tienda

HP eStation Zeen Motherboard Replacement

Introducción

Replacing the motherboard of the HP eStation Zeen is rated a difficult repair, however anyone with patients can do it. The largest challenges for making this repair is paying attention to details and using a light touch. There are screws to keep track of and multiple connections to unfasten and reconnect, but when taking the time to follow steps closely it is no more complex than replacing the 9 volt battery in most smoke detectors.

Qué necesitas

  1. HP eStation Zeen Motherboard Replacement, Motherboard: paso 1, imagen 1 de 3 HP eStation Zeen Motherboard Replacement, Motherboard: paso 1, imagen 2 de 3 HP eStation Zeen Motherboard Replacement, Motherboard: paso 1, imagen 3 de 3

    • Remove the screw caps using the metal spudger.

    • Remove the four 6mm Phillips screws using the Phillips #0 screwdriver.

    Editar

  2. HP eStation Zeen Motherboard Replacement: paso 2, imagen 1 de 3 HP eStation Zeen Motherboard Replacement: paso 2, imagen 2 de 3 HP eStation Zeen Motherboard Replacement: paso 2, imagen 3 de 3

    • Unclip each side of the back cover by inserting the plastic opening tool and sliding it along the edge.

    • Remove the back panel by lifting the panel away from the device.

    Editar

  3. HP eStation Zeen Motherboard Replacement: paso 3, imagen 1 de 1

    • Disconnect battery clip with plastic opening tool.

    • The clip is very fragile.

    Editar

  5. HP eStation Zeen Motherboard Replacement: paso 4, imagen 1 de 1

    • Disconnect the speaker terminal with the plastic opening tool.

    • The clip is very fragile.

    Editar

  6. HP eStation Zeen Motherboard Replacement: paso 5, imagen 1 de 1

    • Disconnect the the volume button clip with metal spudger tool.

    • The clip is fragile.

    Editar

  7. HP eStation Zeen Motherboard Replacement: paso 6, imagen 1 de 1

    • Disconnect the ground wire from the motherboard with tweezers.

    Editar

  8. HP eStation Zeen Motherboard Replacement: paso 7, imagen 1 de 2 HP eStation Zeen Motherboard Replacement: paso 7, imagen 2 de 2

    • Remove the two 6mm Phillips screws with Phillips #0 screwdriver.

    Editar

  9. HP eStation Zeen Motherboard Replacement: paso 8, imagen 1 de 2 HP eStation Zeen Motherboard Replacement: paso 8, imagen 2 de 2

    • Pry off the clips that hold the motherboard down with the plastic spudger.

    Editar

  10. HP eStation Zeen Motherboard Replacement: paso 9, imagen 1 de 2 HP eStation Zeen Motherboard Replacement: paso 9, imagen 2 de 2

    • Lift motherboard up to expose the ribbons on the back.

    • Lift the grey tabs to disconnect the ribbons with plastic spudger.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 6 otros colaboradores

dalton hale

Miembro Desde 09/26/16

503 Reputación

4 Guías creadas

Insignias: 9

+ 6 más insignias

Equipo

USF Tampa, Team 16-4, Eyestone Fall 2016 Miembro de USF Tampa, Team 16-4, Eyestone Fall 2016

USFT-EYESTONE-F16S16G4

4 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 4

Ultimos 30 días: 6

Todo El Tiempo: 538