HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement

Introducción

Follow this guide to open the housing on your HP Windows Mixed Reality Controllers TPC-Q044.

This guide goes over steps for the left controller, but the process is identical for the right controller.

Because most of the components in this device are enclosed within the housing, replacement for nearly all parts will require you to follow these instructions to access the internals.

Qué necesitas

Paso 1 Batteries

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement, Batteries: paso 1, imagen 1 de 3

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement, Batteries: paso 1, imagen 2 de 3

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement, Batteries: paso 1, imagen 3 de 3

Slide the rear compartment cover in the direction of the arrow.
If replacing batteries, ensure the (+) and (-) on the battery match the (+) and (-) labeled in the battery compartment.

Editar

Paso 2 Shell

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement, Shell: paso 2, imagen 1 de 2

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement, Shell: paso 2, imagen 2 de 2

Remove the four 4mm screws using a Phillips #00 screwdriver.

Editar

Paso 3

HP Windows Mixed Reality Controllers TPC-Q044 Shell Replacement: paso 3, imagen 3 de 3

Grip the main body and pull the joystick outwards until the entire front panel pops off.
Remove the 6mm screw in the corner of the joystick well using a Phillips #00 screwdriver.

Editar