Saltar al contenido principal

Introducción

How to remove and replace the Wifi card on an HP ProBook 440 G1.

Partes

No se especificaron partes.

  1. Make sure the laptop is turned off  before you start. Push and hold the release tab on the right and left toward the center.
    • Make sure the laptop is turned off before you start.

    • Push and hold the release tab on the right and left toward the center.

  2. Pull the battery out. Pull the battery out.
    • Pull the battery out.

  3. Push and hold the release tabs on the right and left toward the center again. Push and hold the release tabs on the right and left toward the center again. Push and hold the release tabs on the right and left toward the center again.
    • Push and hold the release tabs on the right and left toward the center again.

  4. Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora

    Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora
  5. Slide the backplate off.
    • Slide the backplate off.

  6. Locate the Wifi card, found opposite the battery and across from the hard drive. Locate the Wifi card, found opposite the battery and across from the hard drive.
    • Locate the Wifi card, found opposite the battery and across from the hard drive.

  7. Remove the wire located near the screws on the wifi card. Remove the wire located near the screws on the wifi card.
    • Remove the wire located near the screws on the wifi card.

  8. Remove the two Phillips #00 screws holding the wifi card in place. Remove the two Phillips #00 screws holding the wifi card in place.
    • Remove the two Phillips #00 screws holding the wifi card in place.

  9. Remove the wifi card.
    • Remove the wifi card.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 12

Todo El Tiempo: 129