Saltar al contenido principal

Introducción

How to remove and replace the keyboard of an HP ProBook 440 G1.

Partes

No se especificaron partes.

  1. Make sure the laptop is turned off  before you start. Push and hold the release tab on the right and left toward the center.
    • Make sure the laptop is turned off before you start.

    • Push and hold the release tab on the right and left toward the center.

  2. Pull the battery out. Pull the battery out.
    • Pull the battery out.

  3. Push and hold the release tabs on the right and left toward the center again. Push and hold the release tabs on the right and left toward the center again. Push and hold the release tabs on the right and left toward the center again.
    • Push and hold the release tabs on the right and left toward the center again.

  4. Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora

    Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora
  5. Slide the backplate off.
    • Slide the backplate off.

  6. Locate the two screws on the back of the laptop, holding the keyboard. Remove the two screws using a Phillips #00 screwdriver.
    • Locate the two screws on the back of the laptop, holding the keyboard.

    • Remove the two screws using a Phillips #00 screwdriver.

  7. Flip the computer over so as to see the keyboard.
    • Flip the computer over so as to see the keyboard.

  8. Place both hands on the keyboard and slide it back. The keyboard will only slide back a small amount.
    • Place both hands on the keyboard and slide it back.

    • The keyboard will only slide back a small amount.

  9. Using a plastic opening tool, pull the keyboard up. Using a plastic opening tool, pull the keyboard up.
    • Using a plastic opening tool, pull the keyboard up.

  10. Locate the connector strip between the keyboard and the laptop. Pull the strip away from the connector until it unplugs. It may take some force to make the strip disconnect.
    • Locate the connector strip between the keyboard and the laptop.

    • Pull the strip away from the connector until it unplugs.

    • It may take some force to make the strip disconnect.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 10

Últimos 30 Días: 52

Todo El Tiempo: 278