Saltar al contenido principal

HP Photosmart c3180 Scanner Bulb Replacement

Qué necesitas

  1. HP Photosmart c3180 Scanner Bulb Replacement, Top Panel of HP Photosmart c3180 printer: paso 1, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement, Top Panel of HP Photosmart c3180 printer: paso 1, imagen 2 de 2
    • Before disassembling your printer, be sure that the printer has been unplugged to avoid any risk of injury.

    • Rotate the printer 90 degrees counter clockwise so that the side panel next to control panel is facing you.

    • Remove the two T10 12mm Torx screws from the left side panel.

  2. HP Photosmart c3180 Scanner Bulb Replacement: paso 2, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 2, imagen 2 de 2
    • Firmly pull the the back of the side panel until it separates from the body of the printer.

    • Rotate the side panel upwards while pulling it towards yourself to remove the panel.

  3. HP Photosmart c3180 Scanner Bulb Replacement: paso 3, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 3, imagen 2 de 2
    • Rotate the printer 90 degrees clockwise.

    • Grasp the paper tray and rotate it down.

    • Insert your fingers into the slot in the printer door and pull to rotate the gate down.

  4. HP Photosmart c3180 Scanner Bulb Replacement: paso 4, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 4, imagen 2 de 2
    • Rotate the printer 90 degrees clockwise.

    • Remove the two T10 12 mm Torx screws.

    • Grasp both sides of the side panel and pull it forward to remove the panel.

  5. HP Photosmart c3180 Scanner Bulb Replacement: paso 5, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 5, imagen 2 de 2
    • Rotate the printer 90 degrees counter clockwise.

    • Lift the scanner lid to expose the scanner glass.

  6. HP Photosmart c3180 Scanner Bulb Replacement: paso 6, imagen 1 de 1
    • Remove the two T10 12 mm Torx screws.

    • Do not attempt to lift the top panel off the printer yet because it is still connected to the printer body by a cable.

  7. HP Photosmart c3180 Scanner Bulb Replacement: paso 7, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 7, imagen 2 de 2
    • Rotate the printer 90 degrees counter clockwise.

    • Inside the printer is a small white tab. Press it inward with a spudger until a pop is heard.

    • Remove the front panel by grasping its front and pulling away from the printer.

    Änderung des Textes: die kleine Lasche verriegelt die kleine Frontblende: mit leichtem Druck Richtung “rechte Druckerseite entriegeln, gleichzeitig jene Blende nach vorn lösen.

    Garofalo - Contestar

  8. HP Photosmart c3180 Scanner Bulb Replacement: paso 8, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 8, imagen 2 de 2
    • Rotate the printer 90 degrees clockwise.

    • Remove the cable connecting the top panel of the printer to the power button assembly.

  9. HP Photosmart c3180 Scanner Bulb Replacement: paso 9, imagen 1 de 1
    • Carefully lift the top panel of the printer away from the printer body.

    nur die dünne weiße Abdeckung, die graue bleibt noch; zuerst hinten anheben, vorn ist mittig eine Nase zu lösen.

    Garofalo - Contestar

  10. HP Photosmart c3180 Scanner Bulb Replacement, Scanner Bulb: paso 10, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement, Scanner Bulb: paso 10, imagen 2 de 2
    • Set aside the top panel of the printer.

    • Lift the scanner carriage vertically, being careful not to yank of the cables connecting it to the printer.

  11. HP Photosmart c3180 Scanner Bulb Replacement: paso 11, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 11, imagen 2 de 2
    • Flip the scanner carriage over to expose the connectors on the bottom.

    • Carefully remove the small cable from the connector.

    • Carefully remove the large cable from the connector.

  12. HP Photosmart c3180 Scanner Bulb Replacement: paso 12, imagen 1 de 2 HP Photosmart c3180 Scanner Bulb Replacement: paso 12, imagen 2 de 2
    • Remove the scanner carriage from the scanner tray and flip it upside down.

    • Remove the two T10 12mm Torx screws.

    • Remove the scanner carriage from the scanner bulb.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Jim

Miembro Desde 10/06/11

1,590 Reputación

10 Guías creadas

Equipo

Cal Poly, Team 20-30, Maness Fall 2011 Miembro de Cal Poly, Team 20-30, Maness Fall 2011

CPSU-MANESS-F11S20G30

4 Miembros

25 Guías creadas

Un comentario

You say no parts needed to be purchased. You have to buy a new scanner bulb if you’re replacing it.

ddaviddierlam - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 15

Todo El Tiempo: 6,043