Esta traducción podría no reflejar los cambios más recientes añadidos a la guía de referencia. Ayúdanos a actualizar la traducción o revisa la guía original.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the flap for the scanner. The flap is attached with two clips that can be dislodged by pulling lightly away from the printer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the three screws on top of the printer.
-
The orange circle shows a fourth screw located behind the power panel. Directions to remove this screw are in a later step.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three screws from the top of the printer with a T-9 screwdriver as shown.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To access and remove the fourth and final screw attaching the hood, the panel for the power button must be removed as follows:
-
Reach into the mouth of the printer and press on the small clip behind the power button. This allows the panel of the power button to be removed.
-
After pressing the clip, pull out the power button panel by pulling from right to left.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the exposed screw that was covered by the power button panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
This step is easier with two people. Carefully have one person lift the hood of the printer 2-3 inches above where it was resting.
-
Remove the ribbon cables and wires attaching the motherboard (the only green PCB board) to the hood by gently pulling upward on them.
-
When all three cables are removed, lift the hood away from the printer and set it aside.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
Un agradecimiento especial a estos traductores:
9%
¡ sarahi alarcon nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›