Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the computer off and disconnect if from all power sources.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Hold the release switch all of the way to the left and your other hand to pull the battery out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove service hatch by sliding away from the computer and lifting up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Push the retraining springs away from the RAM at the same time to unlock the RAM.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the RAM out.
-
Follow the same procedure for the additional RAM.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two Phillips #00 screws holding in the hard drive.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab the black tab on the hard drive and pull left and then upwards to remove.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four Phillips #00 screws holding the hard drive to its case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to pop off the antenna connectors.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove single Phillips #00 screw.
-
Pull the card out by hand.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single Phillips #00 screw.
-
Flip the laptop over.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge a spudger in between the keyboard and the upper bezel (nearest the screen).
-
Pry upward to release the keyboard clips.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to flip up the black tab on the ZIF connectors.
-
Pull the ribbon cables out of the ZIF connectors.
-
Remove the keyboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the keyboard back over.
-
Remove the single Phillips #00 screw holding in the CD drive.
-
Pull out the CD drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the seventeen Phillips #00 screws securing the back panel to the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the laptop over.
-
Remove the single Phillips #00 screw.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to disconnect all wires connected to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up the black tab on the ZIF connector with the flat end of a spudger.
-
Pull the ribbon cable out of the ZIF connector.
-
Remove the fan from the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you have removed the motherboard, the heat sink is attached.
-
Flip over the motherboard/heat sink assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the six screws holding the heat sink onto the motherboard.
-
Unplug the cord supplying power to the fan.
-
Pull the two pieces apart.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.