Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Begin by turning the laptop over so that you can see the bottom of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the battery release switch to the right while simultaneously lifting up the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Loosen the eight Phillips screws around the plate to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the nine Phillips screws from the plate covering the fans.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the lower fan connector from the motherboard.
-
Remove the metal plate and lower fan.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the upper fan connector from the motherboard.
-
Remove the four spring loaded screws holding the heat sink assembly to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the heat sink assembly including the upper fan out by pulling it down and left simultaneously.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Begin after removing the battery and fans.
-
Remove the screws from the outer frame of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove screws from the battery area, noting the following:
-
These screws are on oversize clearing holes, but hold other components on the keyboard. It is not recommended to remove them yet.
-
Two screws secure the optical drive: one in the battery compartment and one in the RAM compartment.
-
With the screws removed, PUSH the optical drive out through the opening at the BLUE arrow. You will need to remove the drive to access two more screws at the edge of the frame in the opening of the optical drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove eight screws from the back panel of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a flathead screwdriver, remove two screws on the left-side panel of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the laptop so that both the screen and keyboard are in view.
-
Carefully pry off the frame above the keyboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To begin disconnecting the monitor, remove two screws.
-
Make sure to keep the screen propped up to reduce the amount of strain on the screws as you take them out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the two wires connecting the monitor to the rest of the laptop.
-
Do not tug on the wires. Just like wall plugs, you need to disconnect them from the actual point of connection.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.