Introducción

This guide will show you how to remove the fans.

Partes

No se requieren partes.

  1. Begin by turning the laptop over so that you can see the bottom of the computer.
    • Begin by turning the laptop over so that you can see the bottom of the computer.

    Agregar Comentario

  2. Slide the battery release switch to the right while simultaneously lifting up the battery.
    • Slide the battery release switch to the right while simultaneously lifting up the battery.

    Agregar Comentario

    • Loosen the eight Phillips screws around the plate to remove it.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the nine Phillips screws from the plate covering the fans.

    • The three screws around the lower fan also hold the fan onto the metal plate.

    Agregar Comentario

    • Lift the plate and lower fan off the heat sink being careful not to damage the lower fan cable, which is attached to the motherboard.

    • Disconnect the lower fan connector from the motherboard.

    • Remove the metal plate and lower fan.

    • The lower fan will easily separate from the metal plate.

    Agregar Comentario

    • Disconnect the upper fan connector from the motherboard.

    • Remove the four spring loaded screws holding the heat sink assembly to the motherboard.

    • When reassembling, ensure that all the screws are equally tightened: thread all screws one turn, then add one turn to each screw in the following order: top left, bottom right, bottom left, top right. Repeat this order until the assembly is firmly seated.

    Agregar Comentario

    • Slide the heat sink assembly including the upper fan out by pulling it down and left simultaneously.

    • When reinstalling the heat sink, ensure it is thoroughly cleaned and the thermal paste (or pads) are replaced to ensure proper thermal contact with the devices on the logic board.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Shantel

Miembro Desde 20/04/10

470 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 30-37, Garner Spring 2010 Miembro de Cal Poly, Team 30-37, Garner Spring 2010

CPSU-GARNER-S10S30G37

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 4

Todo El Tiempo: 6,169