Únete a la Comunidad de Reparación - Crear Cuenta

HP Pavilion Sleekbook 14-b013cl Hard Drive Replacement

James Barlow-Jones y 3 otros contribuidores

Última actualización: 13 de may. de 2021

2.8 k

Ver estadísticas:

Últimas 24 horas:: 2
Últimos 7 días:: 22
Últimos 30 días:: 98
Todo El Tiempo:: 2,837

2 comments on steps.

2 personas han marcado esta guía como "completada". ¿Serás tú la próxima persona en hacerlo?

Nadie ha marcado como "Favorita" ni se ha suscrito a esta guía. ¿Quieres hacerlo tú?

15 - 25 minutos

Moderado

Introducción

Ir al paso 1 ↓

In this guide, you will learn how to replace your HP pavilion Sleekbook's Hard Disk Drive (HDD).

Qué necesitas

Kits de reparación

Este kit contiene todas las piezas y herramientas necesarias para completar esta guía.

Crucial MX500 1 TB SSD
$198.99

5

Partes

Crucial BX500 1TB SSD
$178.99

5

Ver
500 GB 5400 RPM 2.5" Hard Drive
$103.99

4.9

Herramientas

64 Bit Driver Kit
$39.95

4.9
iFixit Opening Tool
4.8

1. Paso 1 Battery
  Flip the computer over and move the battery lock switch to the "unlocked" position (marked by an orange lock icon).
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
2. Paso 2
  Press the switch on the right-hand side of the back of the device towards the center until the gray battery icon is no longer visible. This will eject the battery.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
3. Paso 3
  Carefully pull the battery away from the device.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
1. Paso 4 Hard Drive
  Using a Phillips #0 screwdriver, unscrew all eight of the screws.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
2. Paso 5
  Using a plastic opening tool, pry up on the upper edge of the keyboard.
  
  There is a wire connecting the keyboard to the motherboard. Do not pull the keyboard away until you have disconnected it.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
4. Paso 6
  To disconnect the wire, pry up on the latch holding it in its socket.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
5. Paso 7
  Flip the laptop back over.
  
  Using a plastic or metal spudger, carefully pry the top and bottom halves of the case appart.
  
  Don't push the metal spudger in too far or you might damage the laptops internal components.
  
  Do not pull the halves apart yet as there are still wires attaching them together.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
6. Paso 8
  Disconnect the touch pad wire by flipping the small black lever using a plastic opening tool.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
7. Paso 9
  Unscrew the small circuit board underneath the power button.
  
  Remove the circuit board by pulling up and away on the plastic tab.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
9. Paso 10
  Pull the top half of the plastic case off of the laptop.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
10. Paso 11
  Remove all seven of the screws using a Phillips #0 screwdriver and pull the plate off the motherboard.
  
  There is double sided tape holding the plate down, as well as the screws. Sufficient force will be required to remove the plate.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
11. Paso 12
  Remove the USB wire which runs over the top of the hard drive.
  
  The wire is stuck to the hard drive with double sided tape.
  
  Remove the wire by carefully pulling towards the USB connector on the left hand side of the laptop.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024
12. Paso 13
  Remove the four screws securing the hard drive to the motherboard.
  
  Disconnect the hard drive cable by gently pulling it away from the hard drive.
  Editar
  
  Pregunta a FixBot
  
  Agregar Comentario
  
  1024