Repara tus cosas Comunidad Tienda

HP Omni 10 Speaker Replacement

Introducción

Using a spudger and a 00 Phillips head screwdriver, this guide will show how to remove a pair of speakers from an HP Omni 10 tablet in roughly 5 to 7 minutes.

Qué necesitas

  1. HP Omni 10 Speaker Replacement, Battery: paso 1, imagen 1 de 1

    • Remove the back cover from the tablet.

    • The cover is securely fastened to the device and may be difficult to remove.

    Editar

  2. HP Omni 10 Speaker Replacement: paso 2, imagen 1 de 1

    • Push the black plastic security flaps into an upward position.

    • Lift the small tab on the security strips up and peel them across the battery. They will be attached via adhesive.

    • Lift the tab on the strip up and pull it across the battery.

    • The orange strip does not fully detach from the tablet like the other three. It will only detach from one side.

    Editar

  3. HP Omni 10 Speaker Replacement: paso 3, imagen 1 de 1

    • Unscrew the ten 3.3 mm screws securing the battery using a 00 Phillip's head screwdriver.

    Editar

  4. HP Omni 10 Speaker Replacement: paso 4, imagen 1 de 2 HP Omni 10 Speaker Replacement: paso 4, imagen 2 de 2

    • Unhook the cord from the edge of the battery.

    • Pull the wire circuit out and down.

    Editar

  6. HP Omni 10 Speaker Replacement: paso 5, imagen 1 de 2 HP Omni 10 Speaker Replacement: paso 5, imagen 2 de 2

    • Lift the battery up by its edges and remove it carefully. There will be adhesive holding the battery down.

    Editar

  7. HP Omni 10 Speaker Replacement, Micro Card Reader: paso 6, imagen 1 de 1

    • Unscrew the two 3.3 mm screws using a 00 Phillip's head screwdriver.

    Editar

  8. HP Omni 10 Speaker Replacement: paso 7, imagen 1 de 1

    • Lift and remove micro card reader board.

    Editar

  9. HP Omni 10 Speaker Replacement, Speaker: paso 8, imagen 1 de 1

    • Unscrew the four 3.3 mm screws using a 00 Phillip's head screwdriver.

    Editar

  10. HP Omni 10 Speaker Replacement: paso 9, imagen 1 de 2 HP Omni 10 Speaker Replacement: paso 9, imagen 2 de 2

    • Pull the black and white wire connector up to disconnect it.

    Editar

  11. HP Omni 10 Speaker Replacement: paso 10, imagen 1 de 2 HP Omni 10 Speaker Replacement: paso 10, imagen 2 de 2

    • Pull the red and black wire connector up to disconnect it.

    Editar

  12. HP Omni 10 Speaker Replacement: paso 11, imagen 1 de 1

    • Lift the speaker set out of their sockets.

    • The speakers will also be attached via adhesive. They may be difficult to remove by hand.

    Editar

  13. HP Omni 10 Speaker Replacement: paso 12, imagen 1 de 1

    • Unhook the left speaker's connector wire to fully remove it from the device.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 1 otro colaborador

Alex Miller

Miembro Desde 10/11/16

345 Reputación

5 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

USF Tampa, Team 1-1, Leahy Fall 2016 Miembro de USF Tampa, Team 1-1, Leahy Fall 2016

USFT-LEAHY-F16S1G1

3 Miembros

10 Guías creadas

Un comentario

its order when i will get it please candly I request

Abdul Raheem - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 4

Ultimos 30 días: 14

Todo El Tiempo: 587