Repara tus cosas Comunidad Tienda

HP Envy x360 m6-aq005dx Audio Jack Replacement

Introducción

The where you connect sound devices to the laptop. The USB is the main way to connect new devices to the laptop i.e. flash drive or mouse. This guide will show the proper removal of the laptop's USB port and audio jack.

Qué necesitas

  1. HP Envy x360 m6-aq005dx Audio Jack Replacement, Back Panel: paso 1, imagen 1 de 2 HP Envy x360 m6-aq005dx Audio Jack Replacement, Back Panel: paso 1, imagen 2 de 2

    • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

    Editar

  2. HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 2, imagen 1 de 3 HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 2, imagen 2 de 3 HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 2, imagen 3 de 3

    • Use a Torx T5 screwdriver to remove the six 5.1 mm screws.

    • Use a JIS #1 screwdriver to remove the two 7.2mm screws.

    Editar

  4. HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 3, imagen 1 de 1

    • Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

    Editar

  5. HP Envy x360 m6-aq005dx Audio Jack Replacement, Audio Jack: paso 4, imagen 1 de 1

    • Battery might cause a small electric shock.

    • Use tweezers to disconnect the battery from the motherboard.

    Editar

  6. HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 5, imagen 1 de 2 HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 5, imagen 2 de 2

    • Our pictures show the fan removed from the laptop. You do not need to remove the fan for this guide.

    • Use a PH0 bit to remove the three 4.7 mm screws.

    Editar

  7. HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 6, imagen 1 de 2 HP Envy x360 m6-aq005dx Audio Jack Replacement: paso 6, imagen 2 de 2

    • Use the plastic opening tool to open the security connector. then pull the ribbon cable to disconnect it from the motherboard.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Matthew Martin

Miembro Desde 10/10/17

711 Reputación

5 Guías creadas

Insignias: 16

+ 13 más insignias

Equipo

USF Tampa, Team S13-G17, Cagle Fall 2017 Miembro de USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 350