Saltar al contenido principal

Introducción

This guide covers the HP Envy x360 battery removal.

  1. On the back panel of the device, remove the four (4) M2.5xL6  screws at the top of the photo using a Phillips #0 screwdriver. Unscrew the three (3)  screws at the bottom of the photo using a T5 Torx screwdriver.
    • On the back panel of the device, remove the four (4) M2.5xL6 screws at the top of the photo using a Phillips #0 screwdriver.

    • Unscrew the three (3) screws at the bottom of the photo using a T5 Torx screwdriver.

  2. To remove the back cover, use the black spudger to lift up on the edges of the  cover. Use a suction cup  to assist in lifting the back cover Use a suction cup  to assist in lifting the back cover
    • To remove the back cover, use the black spudger to lift up on the edges of the cover.

    • Use a suction cup to assist in lifting the back cover

  3. Use the Philips #0 screwdriver to remove six (6) M2.0x3.2 screws from battery.
    • Use the Philips #0 screwdriver to remove six (6) M2.0x3.2 screws from battery.

  4. Using the Philips #0 screwdriver, remove the final screw from the battery connected to the SSD storage unit.
    • Using the Philips #0 screwdriver, remove the final screw from the battery connected to the SSD storage unit.

  5. Lift and pull the front of the battery up and out (away from the connector) to remove.
    • Lift and pull the front of the battery up and out (away from the connector) to remove.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Mr. Reihart thank you for this information, could you also say what battery to purchase as a replacement for the 15m -bq.

J r - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 16

Todo El Tiempo: 818