Saltar al contenido principal

HP EliteOne 800 G1 Removing Stand Replacement

Qué necesitas

  1. HP EliteOne 800 G1 Removing Stand Replacement, Removing Stand: paso 1, imagen 1 de 2 HP EliteOne 800 G1 Removing Stand Replacement, Removing Stand: paso 1, imagen 2 de 2
    • Press locking latch on the bottom of the base of the stand.

    • Pull the plastic cover off of the stand.

  2. HP EliteOne 800 G1 Removing Stand Replacement: paso 2, imagen 1 de 2 HP EliteOne 800 G1 Removing Stand Replacement: paso 2, imagen 2 de 2
    • Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.

    • Tilt stand and lift up to remove it.

  3. HP EliteOne 800 G1 Removing Stand Replacement: paso 3, imagen 1 de 2 HP EliteOne 800 G1 Removing Stand Replacement: paso 3, imagen 2 de 2
    • Use a Torx T15 driver to remove the single 10mm screw on the back panel.

    • Pull the back panel toward the bottom of the device to remove it.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Michael Ewing

Miembro Desde 10/01/15

1,071 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 1-24, Maness Fall 2015 Miembro de Cal Poly, Team 1-24, Maness Fall 2015

CPSU-MANESS-F15S1G24

4 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 22

Todo El Tiempo: 3,004