Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the screen face down, lift up the stand as far as it goes.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a T5 driver to remove the six screws on the back of the tablet.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After removing the screws, delicately close the stand.
-
Flip the tablet on its back so that the screen is facing up.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the tape on the lower left side of the screen.
-
Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the flex cable from the device using the spudger.
-
Remove the Display Assembly from the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #0 screwdriver to remove the screw on the left hand side of the card.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slightly lift the card up and then remove the SSD card from the device.
-