Introducción

This guide will help you replace your power module in a HP Color Laser Jet Pro MFP M277dw.

  1. Open and lower the back panel by pulling it down.
    • Open and lower the back panel by pulling it down.

    • Remove one Phillips #2 10 mm screw.

  2. Use the plastic opening tool to remove the right side panel of the printer.
    • Use the plastic opening tool to remove the right side panel of the printer.

    • Flipping the printer on its side, with the right side facing up, will make it easier to remove.

    • Remove two Phillips #2 12mm screws.

    • Remove four different pin connectors that attach to the power module located at the bottom.

    • Removing the white connector is made easier with assistance of a spudger/flat tip that loosens the clamp.

    • Remove two Phillips #2 10mm from the left (front) and right (back) side that attach the power module to the printer.

    • Slowly lift the power module from the printer using both hands.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Lyndon Fresnido

Miembro Desde 08/10/18

121 Reputación

1 Guía escrita

Equipo

Cal Poly, Team S4-G2, White Fall 2018 Miembro de Cal Poly, Team S4-G2, White Fall 2018

CPSU-WHITE-F18S4G2

3 Miembros

5 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 24

Todo El Tiempo: 80