HP Chromebook 11 G3 SD Card Reader Module Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This guide walks through replacing a faulty SD card reader module. It requires removing the keyboard mount. Afterwards, it is relatively simple and requires only a Phillips head screwdriver and a spudger to finish removal.

Qué necesitas

Paso 1 Keyboard Mount

HP Chromebook 11 G3 SD Card Reader Module Replacement, Keyboard Mount: paso 1, imagen 1 de 2

HP Chromebook 11 G3 SD Card Reader Module Replacement, Keyboard Mount: paso 1, imagen 2 de 2

Flip the laptop upside down so that the lid lies flat on the table.
Remove the nine 6mm Phillips #00 screws that line the border.

Traducir

Paso 2

Remove the two rubber feet closest to the hinge using tweezers.
Remove the two 6mm Phillips #00 screws revealed under these rubber feet.
The rubber feet may tear while removal; preventing this can be difficult, but it won’t harm the laptop. If desired, replace these rubber feet during reassembly.

Traducir

Paso 3

Flip the laptop so it is in the upright position.
Open the lid.
Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.
This may require more force than expected. Hearing loud clicks as the plastic opening tool slides along the seam is normal.

Traducir

Paso 4

HP Chromebook 11 G3 SD Card Reader Module Replacement: paso 4, imagen 3 de 3

Tilt the keyboard mount up.
Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.
Gently remove both ribbon cables.

Traducir

Paso 5

Lift the keyboard mount out of the laptop.

Traducir

Paso 6 SD Card Reader Module

HP Chromebook 11 G3 SD Card Reader Module Replacement, SD Card Reader Module: paso 6, imagen 1 de 2

HP Chromebook 11 G3 SD Card Reader Module Replacement, SD Card Reader Module: paso 6, imagen 2 de 2

On the module, use a spudger to lift the small ZIF retaining flap for the ribbon cable connecting the SD card reader to the motherboard.
Gently pull the ribbon cable out of its socket.

Traducir