Saltar al contenido principal

HP 15-g010dx Keyboard Ribbon Cable Replacement

Qué necesitas

  1. HP 15-g010dx Keyboard Ribbon Cable Replacement, Battery: paso 1, imagen 1 de 1
    • Slide the latch towards the center of the laptop so the unlock emblem appears.

  2. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 2, imagen 1 de 1
    • Place your finger on the left latch and slide it towards the center of the laptop.

  3. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 3, imagen 1 de 1
    • Pull on the battery to remove.

  4. HP 15-g010dx Keyboard Ribbon Cable Replacement, Keyboard: paso 4, imagen 1 de 1
    • Remove the two 5 mm screws with the Phillips #00 screwdriver.

  5. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 5, imagen 1 de 1
    • Using either a credit card or flat spudger, wedge it between the palm rest and the keyboard.

  6. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 6, imagen 1 de 1
    • Using the tool of your choice, gently pry up on the top of the keyboard.

  7. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 7, imagen 1 de 1
    • Release the top of the keyboard.

  8. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 8, imagen 1 de 1
    • Remove the ZIF connector that connects the laptop to the keyboard cable.

  9. HP 15-g010dx Keyboard Ribbon Cable Replacement, Keyboard Ribbon Cable: paso 9, imagen 1 de 1
    • Gently lift up on the ZIF connector.

  10. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 10, imagen 1 de 1
    • Now remove the ribbon cable.

  11. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 11, imagen 1 de 1
    • Check for visible damage on the ribbon cable such as folds, kinks, or corrosion.

  12. HP 15-g010dx Keyboard Ribbon Cable Replacement: paso 12, imagen 1 de 1
    • Using your pencil's eraser, gently clean the contact points on the ribbon cable.

Linea de Meta

2 comentarios

my ribbon cable is old, and is not making any good contact, from many times that I have repaired the system, the ribbon cable started not making good contact, because it has inside damage, you know what I mean, it went back and forth many times and it does not want to make good contact, power stops at cable, not board connector

Mitsos Tech Tips - Contestar

I’m the same person, if anyone has the same problem and knows a solution just write it down, I’ll reply as soon as possible

HondaCRX -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 6

Ultimos 30 días: 58

Todo El Tiempo: 5,327