Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn laptop upside down.
-
Flip the lock switch to the unlocked setting.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the release switch.
-
Once the flip is switched, the battery should pop out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two Phillips #1 screws from the RAM panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Release the tabs on each side of the chip by simultaneously pushing each tab away from the RAM.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the sixteen 7mm Phillips #1 screws from the bottom panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 2mm Phillips #00 screws found underneath the disk drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 4mm Phillips #1 screw from the Wi-Fi card.
-
Pull the Wi-Fi card out of the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the laptop.
-
Use a plastic opening tool to pop out the keyboard by starting at the top and working your way around the perimeter.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the screen up until it lays flat and rotate the laptop until the screen is closest to you.
-
Lift the keyboard from the laptop.
-
Use a spudger to lift up the black latch on the ZIF connector and remove the ribbon cable.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 7mm Phillips #1 screws found underneath the keyboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to lift the black tabs on the ZIF connectors.
-
Remove the ribbon cables from the ZIF connectors.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to pop the palm rest off of the laptop.
-
Lift and remove the palm rest.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to lift up the black latch on the ZIF connector.
-
Remove the USB/AUX port ribbon cable from the ZIF connector on the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 7mm Phillips #1 screw from the USB/AUX board.
-
Remove the USB/AUX board from the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the Hard Drive from the laptop.
-
Disconnect the hard drive from the motherboard.
-
Cancelar: No complete esta guía.
9 personas más completaron esta guía.
3 comentarios
This guide helped me so much with my laptop, thanks m8
Hello, i have a question. How much of capacity and technology i could use to upgrade my hard drive?