Saltar al contenido principal

HP 14-ac151nr DC Power Jack Replacement

Qué necesitas

  1. HP 14-ac151nr DC Power Jack Replacement, Backplate: paso 1, imagen 1 de 1
    • Remove battery by pushing the two buttons inward.

  2. HP 14-ac151nr DC Power Jack Replacement: paso 2, imagen 1 de 1
    • Remove the two rubber feet next to the battery.

  3. HP 14-ac151nr DC Power Jack Replacement: paso 3, imagen 1 de 1
    • Remove all 14 Phillips head #0 screws.

  4. HP 14-ac151nr DC Power Jack Replacement: paso 4, imagen 1 de 1
    • Use a plastic opener tool to pry off the black backplate.

  5. HP 14-ac151nr DC Power Jack Replacement, DC Power Jack: paso 5, imagen 1 de 2 HP 14-ac151nr DC Power Jack Replacement, DC Power Jack: paso 5, imagen 2 de 2
    • Remove the black tape near the power jack.

    • Remove the screws connecting monitor to the bottom of the computer.

  6. HP 14-ac151nr DC Power Jack Replacement: paso 6, imagen 1 de 1
    • Position the metal fittings attached to the monitor out of the way.

    • The monitor is still attached by wires — be careful not to pull on it too hard.

  7. HP 14-ac151nr DC Power Jack Replacement: paso 7, imagen 1 de 3 HP 14-ac151nr DC Power Jack Replacement: paso 7, imagen 2 de 3 HP 14-ac151nr DC Power Jack Replacement: paso 7, imagen 3 de 3
    • Disconnect the power jack from the motherboard.

    • Remove the power jack by lifting it up.

    • An opener tool may make this easier.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Antonio Leonti

Miembro Desde 10/26/18

410 Reputación

3 Guías creadas

Equipo

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 418