Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the tab on the back of the device to release the back cover. It should come right off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the battery tab to pull the battery out of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, pry the gray, front face plate until it can be removed from the housing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your screwdriver, remove the four 8.1mm PH00 screws securing the motherboard to the black housing unit and set them aside.
-
Use the plastic opening tool to help pry the motherboard/midframe up from the main housing. Once you can get a hold of the edge, simply pull the internal components up and out!
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the ribbon cable connecting the housing to the motherboard by flicking up the black clip with the spudger tool and gently pulling the cable out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the internal components are removed, take out your handy dandy spudger tool and pry off the piece of tape that holds down the image sensor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your screwdriver, remove the four PH00 screws securing the image sensor to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger tool, pry off the connector ribbon from the motherboard (don't worry it comes off pretty easily).
-
Remove the image sensor from the motherboard assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your screwdriver, remove the three 4mm PH00 screws that hold down the metal plate.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger tool, pry off the corresponding ribbon cable from the motherboard.
-
The microSD/accessory board is ready to come off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your trusty screwdriver, remove the single 3.2mm PH00 screw connecting the motherboard to the midframe.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the spudger tool to disconnect the front LCD from the motherboard. Gently pull the ribbon cable out.
-
Gently pull the motherboard away from the midframe.
-
Cancelar: No complete esta guía.
18 personas más completaron esta guía.
Un comentario
Hello Chad,
Thanks for the very helpful and detailed guide.
Could you please tell us how you narrowed down the problem to the motherboard and not to other parts? What kind of problems were you having with your GoPro before you repaired it? After you have replaced the motherboard and put the camera back together, did you have to do anything else to make it work like reconfigure the firmware?
Appreciate your help. Thanks!