Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the tab on the back of the device to release the back cover. It should come right off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the battery tab to pull the battery out of the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, pry the gray, front face plate until it can be removed from the housing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your screwdriver, remove the four 8.1mm PH00 screws securing the motherboard to the black housing unit and set them aside.
-
Use the plastic opening tool to help pry the motherboard/midframe up from the main housing. Once you can get a hold of the edge, simply pull the internal components up and out!
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the ribbon cable connecting the housing to the motherboard by flicking up the black clip with the spudger tool and gently pulling the cable out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the internal components are removed, take out your handy dandy spudger tool and pry off the piece of tape that holds down the image sensor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your screwdriver, remove the four PH00 screws securing the image sensor to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger tool, pry off the connector ribbon from the motherboard (don't worry it comes off pretty easily).
-
Remove the image sensor from the motherboard assembly.
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.