Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unclip the black latch to the camera case and open the case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pry the back open by inserting a metal spudger between the case and back panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully remove the motherboard and white plastic piece from the case.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
Un comentario
I followed this list, but I think I knocked a component off of the motherboard while I was unscrewing it. I wasn’t planning on ever putting it back together, since I have a newer GoPro camera. Luckily, the lens and the cable connecting it didn’t get damaged. Is there maybe a way to connect the lens to the Raspberry Pi Zero?