Repara tus cosas Comunidad Tienda

GoPro Hero Lens Replacement

Introducción

This guide will entail taking all of the GoPro's components out, as the lens is at the bottom. Because the GoPro Hero is not very repairable, this guide is not for the faint of heart. However, if you follow the steps correctly, you should be able to replace the lens, instead of buying a new camera.

Qué necesitas

  1. GoPro Hero Lens Replacement, Casing: paso 1, imagen 1 de 1

    • Power off your GoPro before beginning disassembly.

    • Unclip the black latch to the camera case and open the case.

    Traducir

  2. GoPro Hero Lens Replacement: paso 2, imagen 1 de 1

    • Gently pry the back open by inserting a metal spudger between the case and back panel.

    Traducir

  3. GoPro Hero Lens Replacement: paso 3, imagen 1 de 1

    • Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.

    Traducir

  5. GoPro Hero Lens Replacement: paso 4, imagen 1 de 1

    • Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.

    Traducir

  6. GoPro Hero Lens Replacement: paso 5, imagen 1 de 1

    • Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.

    • Make sure to keep track of these screws as they are very small.

    Traducir

  7. GoPro Hero Lens Replacement: paso 6, imagen 1 de 1

    • Carefully remove the motherboard and white plastic piece from the case.

    Traducir

  8. GoPro Hero Lens Replacement, Lens: paso 7, imagen 1 de 1

    • Remove the four screws from the lens.

    • These screws are smaller than the ones removed from the white plastic piece.

    Traducir

  9. GoPro Hero Lens Replacement: paso 8, imagen 1 de 1

    • Remove the lens from the case.

    Traducir

    Spot on... Contacted Gopro preciously & they say it's not a replaceable item!.. how wrong are they!

    Thank you.

    Gary Traviss - Contestar

Conclusión

To reassemble your device, follow the instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 5 otros colaboradores

River Drake

Miembro Desde 04/02/15

1,023 Reputación

5 Guías creadas

Insignias: 15

+ 12 más insignias

Equipo

Cal Poly, Team 12-2, Lancaster Spring 2015 Miembro de Cal Poly, Team 12-2, Lancaster Spring 2015

CPSU-LANCASTER-S15S12G2

4 Miembros

18 Guías creadas

Un comentario

I followed this list, but I think I knocked a component off of the motherboard while I was unscrewing it. I wasn’t planning on ever putting it back together, since I have a newer GoPro camera. Luckily, the lens and the cable connecting it didn’t get damaged. Is there maybe a way to connect the lens to the Raspberry Pi Zero?

Doggo Boi - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 5

Ultimos 7 días: 8

Ultimos 30 días: 46

Todo El Tiempo: 12,369