Repara tus cosas Comunidad Tienda

GoPro Hero 3 Silver Rear Housing Replacement

Qué necesitas

  1. GoPro Hero 3 Silver Rear Housing Replacement, Battery: paso 1, imagen 1 de 2 GoPro Hero 3 Silver Rear Housing Replacement, Battery: paso 1, imagen 2 de 2

    • Pull back on the tab on the back of GoPro to open the battery cover.

    Editar

  2. GoPro Hero 3 Silver Rear Housing Replacement: paso 2, imagen 1 de 1

    • Pull the battery out using the tab.

    Editar

  3. GoPro Hero 3 Silver Rear Housing Replacement, Rear Housing: paso 3, imagen 1 de 2 GoPro Hero 3 Silver Rear Housing Replacement, Rear Housing: paso 3, imagen 2 de 2

    • Use the plastic opening tool to remove the faceplate.

    • There is some adhesive and clips so be careful and the faceplate should pop right off.

    Editar

  5. GoPro Hero 3 Silver Rear Housing Replacement: paso 4, imagen 1 de 2 GoPro Hero 3 Silver Rear Housing Replacement: paso 4, imagen 2 de 2

    • Now that the faceplate is off, it is time to remove the 4 screws on each corner.

    • Use the T4 tool bit from the iFixit toolkit in order to remove the 4 screws on each corner.

    Editar

  6. GoPro Hero 3 Silver Rear Housing Replacement: paso 5, imagen 1 de 2 GoPro Hero 3 Silver Rear Housing Replacement: paso 5, imagen 2 de 2

    • Note: Make sure you remove the door cover of the USB, mini HDMI, and SD port before. Separating the motherboard will be easier.

    • Using the plastic opening tool, slowly pry open the motherboard assembly.

    Editar

  7. GoPro Hero 3 Silver Rear Housing Replacement: paso 6, imagen 1 de 2 GoPro Hero 3 Silver Rear Housing Replacement: paso 6, imagen 2 de 2

    • Use the spudger to gently pry off the connector of the housing to the motherboard.

    • You should now have the motherboard assembly and the housing separated.

    Editar

  8. GoPro Hero 3 Silver Rear Housing Replacement: paso 7, imagen 1 de 1

    • In order to replace the buttons. The entire housing has to be replaced.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 5 otros colaboradores

Brian Alvarez

Miembro Desde 04/02/15

1,439 Reputación

6 Guías creadas

Insignias: 15

+ 12 más insignias

Equipo

Cal Poly, Team 24-7, Lancaster Spring 2015 Miembro de Cal Poly, Team 24-7, Lancaster Spring 2015

CPSU-LANCASTER-S15S24G7

3 Miembros

21 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 6

Todo El Tiempo: 2,262