Geardup RC Ford Mustang GT Remote Circuit Board Replacement

Introducción

The circuit board of the remote transmits the movement instructions to the car. If the remote isn't transmitting, the following steps will show you how to replace the circuit board.

Note: This guide will involve soldering. For information on how to solder, please visit iFixit's Soldering Skills page.

Qué necesitas

Paso 1 Lower Remote Control

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: paso 1, imagen 1 de 3

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: paso 1, imagen 2 de 3

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Lower Remote Control: paso 1, imagen 3 de 3

Remove the 5mm Phillips #0 screw from the remote control.
Using the tab, lift the battery cover from the remote control to expose the battery.

Traducir

Paso 2 Remote Circuit Board

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Remote Circuit Board: paso 2, imagen 1 de 2

Geardup RC Ford Mustang GT Remote Circuit Board Replacement, Remote Circuit Board: paso 2, imagen 2 de 2

Unscrew the six 5mm Phillips #0 screws on the back of the remote
Separate the back of the remote from the front panel.
During re-assembly, make sure the plastic button covers on the front panel align with the buttons on the back panel. If they do not, the buttons may be forced into an always "pressed" state.

Traducir

Paso 3

Remove the two left and right buttons from their insets in the controller.

Traducir

Paso 4

Remove the 5mm Phillips #0 screw that connects the antennae to the circuit board.

Traducir

Paso 5

Unscrew 5mm Phillips #0 screw located at the bottom of the board in the center.
Remove the circuit board from the casing.

Traducir

Paso 6

Make note of where each wire connects to the circuit board for re-assembly as they will be removed in the next step.
Using the copper solder wick, remove the solder connecting the nine wires to the circuit board.

Traducir