Repara tus cosas Comunidad Tienda

Gateway SA1 Hard Drive Replacement

Introducción

Upgrading the hard drive capacity by replacing the original drive.

Qué necesitas

  1. Gateway SA1 Hard Drive Replacement, Battery: paso 1, imagen 1 de 1

    • Move the latch to the right of the battery to unlock.

    Traducir

  2. Gateway SA1 Hard Drive Replacement: paso 2, imagen 1 de 1

    • Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.

    • The latch must be held in position to remove the battery.

    Traducir

  4. Gateway SA1 Hard Drive Replacement, Hard Drive: paso 3, imagen 1 de 1

    • Before you begin, it's recommended that you back up all your computer's information on the original hard drive. Also, verify the laptop is off and all cables are disconnected.

    • Turn the laptop over so the bottom is facing up.

    Traducir

  5. Gateway SA1 Hard Drive Replacement: paso 4, imagen 1 de 2 Gateway SA1 Hard Drive Replacement: paso 4, imagen 2 de 2

    • Loosen the three Philips cover screws that secure the hard drive.

    • These screws cannot be fully removed from the hard drive cover.

    • Use the spudger to lift and to remove the hard drive cover.

    Traducir

  6. Gateway SA1 Hard Drive Replacement: paso 5, imagen 1 de 2 Gateway SA1 Hard Drive Replacement: paso 5, imagen 2 de 2

    • Slide the original hard drive to the left and lift it to remove.

    • Insert the new hard drive.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Autor

con 7 otros colaboradores

Diego Carteno

Miembro Desde 04/15/10

258 Reputación

7 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

Cal Poly, Team 24-20, Regan Spring 2010 Miembro de Cal Poly, Team 24-20, Regan Spring 2010

CPSU-REGAN-S10S24G20

4 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 6

Ultimos 30 días: 14

Todo El Tiempo: 13,891