Introducción

You are going to remove the back cover, remove wires and screws from the Wireless Card, and take it out. You can then either reassemble it or replace it.

Partes

No se requieren partes.

  1. Place the laptop so the back cover is facing up.
    • Place the laptop so the back cover is facing up.

  2. Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
    • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

  3. Lift off the cover.
    • Lift off the cover.

  4. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  5. The wireless card is located to the right of the hard drive and below the RAM.
    • The wireless card is located to the right of the hard drive and below the RAM.

  6. There are black and grey wires with gold heads attached to the top of the wireless card.
    • There are black and grey wires with gold heads attached to the top of the wireless card.

    • To remove these wires, turn the gold heads counterclockwise and pull up.

    • You will hear a snap when the heads come off.

    • It does not matter which wire you remove first, but do so one at a time.

  7. Remove the two screws next to the wires with a Phillips #00 screw driver.
    • Remove the two screws next to the wires with a Phillips #00 screw driver.

  8. The card will pop up 20 degrees and is loose enough to remove with your hand.
    • The card will pop up 20 degrees and is loose enough to remove with your hand.

    • Carefully pull the card out to the left horizontally.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Toni Pipes

Miembro Desde 05/10/10

297 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 21-31, Regan Fall 2010 Miembro de Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 4

Todo El Tiempo: 3,858