Saltar al contenido principal

Introducción

This guide demonstrates how to safely remove and replace the RAM stick of a Gateway LT2104u.

Partes

No se especificaron partes.

  1. Locate the the "L" shaped cover on the back, lower right hand side the device. Using a Philips screwdriver, remove the screw holding it in.
    • Locate the the "L" shaped cover on the back, lower right hand side the device. Using a Philips screwdriver, remove the screw holding it in.

  2. Gently lift the cover until it detaches from the device. Gently lift the cover until it detaches from the device.
    • Gently lift the cover until it detaches from the device.

  3. Gently push the levers on each side of the stick of RAM away from each other until the RAM springs into a 45° angle. Gently push the levers on each side of the stick of RAM away from each other until the RAM springs into a 45° angle.
    • Gently push the levers on each side of the stick of RAM away from each other until the RAM springs into a 45° angle.

  4. Carefully remove the stick of RAM by pulling at the same 45° angle the RAM is currently at until it detaches from the device.
    • Carefully remove the stick of RAM by pulling at the same 45° angle the RAM is currently at until it detaches from the device.

  5. When inserting the new stick of ram, be sure to insert it at the same 45° angle that the old stick of ram was taken out at. Press the stick of RAM down until it clicks into place.
    • When inserting the new stick of ram, be sure to insert it at the same 45° angle that the old stick of ram was taken out at. Press the stick of RAM down until it clicks into place.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Chris Sullivan

Miembro Desde 29/03/16

234 Reputación

2 Guías creadas

Equipo

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 3

Todo El Tiempo: 196