Saltar al contenido principal

Garmin eTrex Vista H Replacing Antenna Replacement

Qué necesitas

  1. Garmin eTrex Vista H Replacing Antenna Replacement, Removing Battery: paso 1, imagen 1 de 1
    • Flip the device to the backside, and locate the metal tab at the center of the back cover.

  2. Garmin eTrex Vista H Replacing Antenna Replacement: paso 2, imagen 1 de 1
    • Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.

  3. Garmin eTrex Vista H Replacing Antenna Replacement: paso 3, imagen 1 de 2 Garmin eTrex Vista H Replacing Antenna Replacement: paso 3, imagen 2 de 2
    • Lift the battery plate off to either insert or remove 2 AA batteries.

  4. Garmin eTrex Vista H Replacing Antenna Replacement, Disassembling the Garmin eTrex Vista-H Outer Case: paso 4, imagen 1 de 2 Garmin eTrex Vista H Replacing Antenna Replacement, Disassembling the Garmin eTrex Vista-H Outer Case: paso 4, imagen 2 de 2
    • With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body.

  5. Garmin eTrex Vista H Replacing Antenna Replacement: paso 5, imagen 1 de 3 Garmin eTrex Vista H Replacing Antenna Replacement: paso 5, imagen 2 de 3 Garmin eTrex Vista H Replacing Antenna Replacement: paso 5, imagen 3 de 3
    • With the pick side of a spudger (or tweezers), peel the sticky tape from the device.

  6. Garmin eTrex Vista H Replacing Antenna Replacement: paso 6, imagen 1 de 1
    • Split the front and rear panels by inserting a small pointed tool (such as a pen point or a screwdriver tip SL1.5) in the 5 plastic tabs along the sides of the device.

    • Do not remove the back panels quickly. If too much force is applied, there is a wire connection that will break.

    • CAUTION! Be careful not to force the tabs inward. This will result in broken tabs.

  7. Garmin eTrex Vista H Replacing Antenna Replacement: paso 7, imagen 1 de 2 Garmin eTrex Vista H Replacing Antenna Replacement: paso 7, imagen 2 de 2
    • With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard.

  8. Garmin eTrex Vista H Replacing Antenna Replacement, Disassembling Garmin eTrex Vista H Motherboard: paso 8, imagen 1 de 1
    • The motherboard should look like this. If it is dirty, gently use a small paintbrush to clean it of dust.

  9. Garmin eTrex Vista H Replacing Antenna Replacement: paso 9, imagen 1 de 1
    • There are no screws holding the motherboard in place.

    • Carefully lift the motherboard from the case.

  10. Garmin eTrex Vista H Replacing Antenna Replacement: paso 10, imagen 1 de 2 Garmin eTrex Vista H Replacing Antenna Replacement: paso 10, imagen 2 de 2
    • With the pointed end of a spudger (or the small end of a Philips #00 screwdriver), gently unhook the small black tabs by pressing into the interlocking hooks that are sunk into the white wire connector.

    • Gently pull the wire ribbon from the white connector.

    It is easy to pull the ribbon cable off, but reinserting the ribbon cable back into the wire connector is very challenging. Any tips?

    Robin Van Eyk - Contestar

  11. Garmin eTrex Vista H Replacing Antenna Replacement, Replacing Antenna: paso 11, imagen 1 de 1
    • Locate antenna on the back of the motherboard.

    • In order to replace the antennaa you have to purchase a new motherboard.

    Dear Sir, I need Displays for etrexH,and etrex10 where i can buy ...thanks

    shiva raj - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

Cal Poly, Team 21-30, Regan Fall 2010 Miembro de Cal Poly, Team 21-30, Regan Fall 2010

CPSU-REGAN-F10S21G30

3 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 4,536