GameSir X2 Type-C Back Cover Replacement

Introducción

If you need to open or replace the back cover of the GameSir X2 Type-C, use this guide. This guide provides access to the left joystick and trigger assembly. This guide is a pre-requisite for most replacements inside the housing of the device.

Qué necesitas

Paso 1 Back Cover

GameSir X2 Type-C Back Cover Replacement, Back Cover: paso 1, imagen 1 de 2

GameSir X2 Type-C Back Cover Replacement, Back Cover: paso 1, imagen 2 de 2

Turn the device so the back faces you.

Editar

Paso 2

Remove the eight 6 mm T6 Torx screws.

Editar

Paso 3

Use a straight edge to remove the rubber pad on the front of the device.

Editar

Paso 4

Remove the four 4.5 mm screws with a Phillips #000 screwdriver.

Editar

Paso 5

Use a straight edge to pry open the controller, following the seam on the controller.
Some force is necessary, but be careful not to damage any of the clips holding the controller together.

Editar